Show Cep Policy - Enterasys Matrix DFE-Gold Series Configuration Manual

show cep policy

Parameters
detection‐id
Defaults
If no detection‐id is specified, all CEP detection parameters are displayed.
Mode
Read‐Only.
Examples
This example shows how to display CEP detection information:
Matrix>show cep detection
Global CEP state enabled
Detection Rules for Index 1:
Endpoint Phone Type h323
Protocol tcp & udp
Port Low 1718
Port High 1720
Address Type unknown
Address
Mask Type unknown
Mask
Row Status enabled
show cep policy
Use this command to display the global policies of all supported CEP types.
Syntax
show cep policy
Parameters
None.
Defaults
None
Mode
Read‐Only.
Configuring Convergence End Points (CEP) Phone Detection
(Optional) Show CEP detection parameters, based on the CEP
configuration group id.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-41