ip irdp
Configuring IRDP
Purpose
To enable and configure the ICMP Router Discovery Protocol (IRDP) on an interface. This protocol
enables a host to determine the address of a router it can use as a default gateway.
Commands
For information about...
ip irdp
ip irdp maxadvertinterval
ip irdp minadvertinterval
ip irdp holdtime
ip irdp preference
ip irdp address
no ip irdp multicast
show ip irdp
ip irdp
Use this command to enable or disable IRDP on an interface.
Syntax
ip irdp
no ip irdp
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command disables IRDP on an interface.
Example
This example shows how to enable IRDP on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp
Enterasys Matrix DFE-Gold Series Configuration Guide 21-55
Configuring IRDP
Refer to page...
21-55
21-56
21-56
21-57
21-58
21-58
21-59
21-59