set spantree bridgehellomode
Example
This example shows how to display the Spanning Tree bridge hello mode. In this case, a single
bridge hello mode has been enabled using the set spantree bridgehellomode command as
described in "set spantree hello" on page 6‐24:
Matrix(rw)->show spantree bridgehellomode
Bridge Hello Mode is currently enabled.
set spantree bridgehellomode
Use this command to enable or disable bridge hello mode on the device.
Syntax
set spantree bridgehellomode {enable | disable}
Parameters
enable
disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable single Spanning Tree hello mode on the device. Per‐port hello
times can now be configured using the set spantree porthellomode command as described in "set
spantree porthello" on page 6‐56:
Matrix(rw)->set spantree bridgehellomode disable
clear spantree bridgehellomode
Use this command to reset the Spanning Tree administrative hello mode to enabled.
Syntax
clear spantree bridgehellomode
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Enables single Spanning Tree bridge hello mode.
Disables single Spanning Tree bridge hello mode, allowing for the
configuration of per‐port hello times.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-23
Configuring Spanning Tree Bridge Parameters