Show Radius-Snooping Flow; Radius-Snooping Port Settings - Enterasys Matrix DFE-Gold Series Configuration Manual

show radius-snooping flow

Table 26-2 Radius-Snooping Port Settings
Output...
Port
Port State
Timeout
Drop State
Allowed
Allocated
show radius-snooping flow
Use this command to display information for all flows or the specified index entry in the flow
table.
Syntax
show radius-snooping flow {index | all}
Parameters
index
all
Defaults
None.
Mode
Read‐Write.
Usage
Use the index to specify a particular flow to display, otherwise use all.
Example
This example displays the flow information for index 1:
Matrix(rw)->show radius-snooping flow 1
FlowID
1
Number of current sessions
Number pending
Total Sessions:
Total RADIUS Access Requests
What it displays...
Specifies the port(s) currently enabled for RS.
Specifies the actual port state.
Specifies the amount of time in seconds before the session will be terminated
if no response is seen from the RADIUS server once a request is seen from
the client.
Specifies whether Drop State is enabled or disabled for sessions on this port.
Specifies the maximum number of sessions allowed by license for this port.
Specifies the number of allocated sessions as set in the command
snooping port on page
Specifies a specific flow table index entry to be displayed.
Specifies that all flow table entries are to be displayed.
Client IP Server IP
192.10.20.5 192.10.10.10
26-4.
UDP Port Validation
1812 Enabled
: 17
: 4
: 85
: 242
Enterasys Matrix DFE-Gold Series Configuration Guide 26-9
Understanding RADIUS Snooper
set radius-