show igmp protocols
show igmp protocols
Use this command to display the binding of IP protocol id to IGMP classification.
Syntax
show igmp protocols
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the binding of IP protocol id to IGMP classification:
Matrix(rw)->show igmp protocols
Protocol Classifications
Protocol Ids set to Mcast Data
17
Protocol Ids set to routing Protocol
3,7-9,42-43,45,47-48,85-86,88-89,91-92,100,103,112
Protocol Ids set to Ignore
0,4-6,10-16,18-41,44,46,49-84,87,90,93-99,101-102,104-111,113-255
set igmp protocols
Use this command to changes the IGMP classification of received IP frames
Syntax
set igmp protocols [classification classification] [protocol-id protocol-id]
[modify]
Parameters
classification
classification
protocol‐id protocol‐id
modify
Specifies the classification. Options are:
•
1-multicast data
•
2-routing protocol
•
3-ignore
The protocol ids to change(0‐255).
Add to existing classifications. If not used, protocols will be
overwritten.
Enterasys Matrix DFE-Gold Series Configuration Guide 9-13
Configuring IGMP