Set Port Trap; Show Linkflap - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Link Traps and Link Flap Detection
Mode
Switch command, Read‐Write.
Example
This example shows how to display link trap status for fe.3.1 through 4:
Matrix(rw)->show port trap fe.3.1-4
Link traps enabled on port fe.3.1.
Link traps enabled on port fe.3.2.
Link traps enabled on port fe.3.3.
Link traps enabled on port fe.3.4.

set port trap

Use this command to enable or disable ports for sending SNMP trap messages when their link
status changes.
Syntax
set port trap port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable link traps for Fast Ethernet port 3 in module3:
Matrix(rw)->set port trap fe.3.3 disable

show linkflap

Use this command to display link flap detection state and configuration information.
Syntax
show linkflap {globalstate | portstate | parameters | metrics | portsupported |
actsupported | maximum | downports | action | operstatus | threshold | interval]
| downtime | currentcount | totalcount | timelapsed | violations [port-string]}
4-40 Port Configuration
Specifies the port(s) for which to enable or disable link trap messages.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Enables or disables link traps.
set port trap