Show Ip Pim Rp-Hash; Show Ip Mroute - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring PIM

show ip pim rp-hash

Use this command to display the rendezvous point (RP) that is being selected for a specified
group.
Syntax
show ip pim rp-hash group-address
Parameters
group‐address
Defaults
None.
Mode
Router command, Privileged EXEC: Matrix>Router#
Example
This example shows how to display RP hash information:
Matrix>Router#show ip pim rp-hash
RP 192.168.41.1, via

show ip mroute

Use this command to display the IP multicast routing table.
Syntax
show ip mroute [unicast-source-address | multicast-group-address] [summary]
Parameters
unicast‐source‐address |
multicast‐group‐address
summary
Defaults
If no optional parameters are specified, detailed information about all source and destination
addresses will be displayed.
Mode
Router command, Any router mode.
Usage
This table shows how a multicast routing protocol, such as PIM and DVMRP, will forward a
multicast packet. Information in the table includes source network/mask and upstream neighbors.
For more information on configuring DVMRP, refer to "Configuring DVMRP" on page 21‐52.
17-10 PIM Configuration
Displays information about a specific group address.
Bootstrap Router, uptime 07:50:10, expires 00:01:52
(Optional) Displays information about a specific unicast source address
or multicast destination address.
(Optional) Displays a summary of information.
show ip pim rp-hash