Set Router Limits (Nat) - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Network Address Translation (NAT)

set router limits (NAT)

Use this command to set NAT configuration limits.
Syntax
set router limits {nat-bindings nat-bindings | nat-cache nat-cache |
nat-dynamic-configs nat-dynamic-configs | nat-static-config nat-static-config |
nat-interface-config nat-interface-config | nat-global-addr-cfg
nat-global-addr-cfg | nat-global-port-cfg nat-global-port-cfg}
Parameters
nat‐bindings
nat‐bindings
nat‐cache
nat‐cache
nat‐dynamic‐configs
nat‐dynamic‐configs
nat‐static‐config
nat‐static‐config
nat‐interface‐config
nat‐interface‐config
nat‐global‐addr‐cfg
nat‐global‐addr‐cfg
nat‐global‐port‐cfg
nat‐global‐port‐cfg
Defaults
None.
Mode
Switch Command: Matrix(rw)‐>.
Usage
Bindings and cache use valuable memory resources. By default these setting are set to maximum
values. Use this command to free memory resources by limiting the number of bindings and cache
size.
The chassis or system must be rebooted for any new change to take effect.
This command must be executed from the switch CLI.
18-14 Network Address Translation (NAT) Configuration
(Optional) Specifies the maximum number of NAT bindings for this
router. Values range from 500 to 32000. Default value of 32000.
(Optional) Specifies the maximum NAT cache size for this router. Values
range from 100 to 2000. Default value of 2000.
(Optional) Specifies the maximum number of dynamic mapping
configurations. Values range from 1 to 10. Default value of 10.
(Optional) Specifies the maximum number of NAT static mapping
configurations for this router. Values range from 1 ‐ 50. Default value of
50.
(Optional) Specifies the maximum number of NAT interface
configurations. Values range from 4 ‐ 103. Default value of 103.
(Optional) Specifies the maximum number of NAT global address
configurations for this router. Values range from 1 ‐ 1000. Default value
of 1000.
(Optional) Specifies the maximum number of NAT global port
configurations for this router. Values range from 1 ‐ 32000. Default value
of 32000.
Note: Router limits can also be set in the following contexts:
To set LSNAT router limits see
To set TWCB router limits see
set router limits (LSNAT) on page
set router limits (TWCB) on page
set router limits (NAT)
19-33.
23-15.