Client-Identifier - Enterasys Matrix DFE-Gold Series Configuration Manual

client-identifier

Parameters
name
Defaults
None.
Mode
Router command, Any DHCP configuration mode.
Usage
Using this command to give a set of client class properties a name, allows you to assign properties
to all DHCP clients within the class rather than configuring each client separately. This command
also enables DHCP class configuration mode.
The "no" form of this command deletes a client class name.
Example
This example shows how to assign "clientclass1" as a client class name in the "localpool" address
pool:
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-class clientclass1
client-identifier
Use this command to enable DHCP host configuration mode and associate a client class with a
DHCP client.
Syntax
client-identifier mac-address [client-class name]
no client-identifier unique-identifier
Parameters
mac‐address
client‐class name
Defaults
If client‐class is not specified, none will be assigned.
Mode
Router command, Any DHCP configuration mode.
Usage
The "no" form of this command deletes a client identifier.
Specifies a name for a DHCP client class.
Specifies the client's MAC address.
(Optional) Specifies the class to which this client will be assigned. Must
be configured using the client‐class name as described in "client‐class"
on page 20‐16.
Enterasys Matrix DFE-Gold Series Configuration Guide 20-17
DHCP Overview