Set Logout; Show Physical Alias - Enterasys Matrix DFE-Gold Series Configuration Manual

set logout

set logout
Use this command to set the time (in minutes) an idle console or Telnet CLI session will remain
connected before timing out.
Syntax
set logout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the system timeout to 10 minutes:
Matrix(rw)->set logout 10

show physical alias

Use this command to display the alias, a text name, for one or more physical objects.
Syntax
show physical alias [chassis] | [slot slot] | [backplane backplane] | [module
module] | [powersupply powersupply] | [powersupply-slot powersupply-slot] | [fan]
| [fan-slot] | [port-string port-string]
Parameters
chassis
slot slot
backplane backplane
module module
powersupply
powersupply
powersupply‐slot
powersupply‐slot
fan
Sets the number of minutes the system will remain idle before timing
out.
(Optional) Displays the alias set for the chassis.
(Optional) Displays the alias set for a specified slot in the chassis.
(Optional) Displays the alias set for the backplane. Valid values are 1 for
FTM 1 and 2 for FTM 2.
(Optional) Displays the alias set for a specified module. A maximum of
one module alias per slot is allowed.
(Optional) Displays the alias set for a specified power supply. Valid
values are 1 or 2.
(Optional) Displays an alias set for a specific power supply slot.
(Optional) Displays the alias set for the fan tray.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-53
Setting Basic Device Properties