Router Ospf - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring OSPF
Table 21-2 OSPF Configuration Task List and Commands (continued)
To do this...
Enable passive OSPF mode on an interface.
Enable redistribution from non-OSPF routes.
Limit link state database overflow.
Enable graceful restart
Disable graceful restart helper
Setting the graceful restart restart-interval
Disabling strict LSA checking for graceful
restart
Monitor and maintain OSPF.
Enable RFC1583 compatibility

router ospf

Use this command to enable or disable Open Shortest Path First (OSPF) configuration mode.
Syntax
router ospf process-id
no router ospf process-id
Parameters
process‐id
Defaults
None.
21-22 Routing Protocol Configuration
Use these commands...
passive-interface ("passive-interface" on page 21-36)
redistribute ("redistribute" on page 21-37)
database-overflow ("database-overflow" on page 21-38)
graceful-restart enable
page 21-39)
graceful-restart helper-disable
disable" on page 21-40)
graceful-restart restart-interval
interval" on page 21-40)
graceful-restart strict-lsa-checking-disable
restart
show ip ospf
show ip ospf database
page 21-43)
show ip ospf border-routers
on page 21-45)
show ip ospf interface
page 21-45)
show ip ospf neighbor
page 21-47)
show ip ospf virtual-links
page 21-48)
clear ip ospf process
page 21-49)
debug ip ospf
rfc1583compatible ("rfc1583compatible" on page 21-50)
Specifies the process ID, an internally used identification number for an
OSPF routing process run on a router. Only one OSPF process is
allowed per device. Valid values are 1 to 65535.
("graceful-restart
("graceful-restart helper-
("graceful-restart restart-
strict-lsa-checking-disable" on page 21-41)
("show ip ospf" on page 21-42)
("show ip ospf
("show ip ospf
("show ip ospf
("show ip ospf
("show ip ospf
("clear ip ospf
("debug ip ospf" on page 21-50)
router ospf
enable" on
("graceful-
database" on
border-routers"
interface" on
neighbor" on
virtual-links" on
process" on