Clear Vlan Interface; Show Port Ingress Filter - Enterasys Matrix DFE-Gold Series Configuration Manual

clear vlan interface

clear vlan interface
Use this command to clear the MIB‐II interface entry mapped to a VLAN.
Syntax
clear vlan interface vlan-list
Parameters
vlan‐list
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the interface entry mapped to VLAN 1:
Matrix(rw)->clear vlan interface 1

show port ingress filter

Use this command to show all ports that are enabled for port ingress filtering, which limits
incoming VLAN ID frames according to a port VLAN egress list.
Syntax
show port ingress-filter [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, ingress filtering status for all ports will be displayed.
Mode
Switch command, Read‐Only.
Usage
If the VLAN ID specified in the received frame is not on the port's VLAN egress list, then that
frame is dropped and not forwarded.
Specifies the VLAN(s) for which an interface entry will be cleared.
(Optional) Specifies the port(s) for which to display ingress filtering
status. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 7-13
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering