Show Ipv6 Traffic; Show Ipv6 Summary Output Details - Enterasys SECURESTACK C3 Configuration Manual

Table 22-4 show ipv6 summary Output Details
Output Field
Connected Routes
Static Routes
OSPF Routes
Number of Prefixes
Total Routes

show ipv6 traffic

Use this command to show traffic and statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [interface]
Parameters
interface
Defaults
If no interface is specified, information about traffic on all interfaces is displayed.
Mode
Router privileged execution: C3(su)‐>router#
Usage
Specify a logical, loopback, or tunnel interface to view information about traffic on a specific
interface. If you do not specify an interface, the command displays information about traffic on all
interfaces.
Example
The following example displays the output of this command.
C3(su)->router>show ipv6 traffic
IPv6 STATISTICS
Total Datagrams Received.................................. 116
Received Datagrams Locally Delivered...................... 116
Received Datagrams Discarded Due To Header Errors......... 0
Received Datagrams Discarded Due To MTU................... 0
Received Datagrams Discarded Due To No Route.............. 0
Received Datagrams With Unknown Protocol.................. 0
Received Datagrams Discarded Due To Invalid Address....... 0
Received Datagrams Discarded Due To Truncated Data........ 0
Received Datagrams Discarded Other........................ 0
What It Displays...
Total number of connected routes in the routing table.
Total number of static routes in the routing table.
Total number of routes installed by OSPFv3 protocol.
Summarizes the number of routes with prefixes of different lengths
Total number of routes in the routing table.
(Optional) Specifies the interface for which traffic information should be
displayed. Interface can be of the form:
vlan vlan‐id
tunnel tunnel‐id
loopback loop‐id
show ipv6 traffic
SecureStack C3 Configuration Guide 22-29