Show Rmon Topn Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RMON
Example
This example shows how to display all RMON TopN properties and statistics. A control entry
displays first, followed by actual entries corresponding to the control entry:
Matrix(rw)->show rmon topN
--------------------
Index
Status
Owner
Start Time
HostIndex
Rate Base
Duration
Time Remaining = 0
Requested Size = 10000
Granted Size
Report 1
-------------------
Rate = 3
Address = 0.1.f4.6.2e.40
Table 11‐6 provides an explanation of the command output. Properties are set using the set rmon
topN properties command as described in "set rmon topN properties" on page 11‐31.
Table 11-6 show rmon topN Output Details
Output...
Index
Status
Owner
Start Time
HostIndex
Rate Base
Duration
Time Remaining
Requested Size
Granted Size
Rate
Address
11-30 Network Monitoring Configuration
= 1
= 1 valid
= monitor
= 0
= 1
= 1 InPkts
= 10
= 100
What it displays...
Index number for this event entry. Each entry defines one top N report
prepared for one interface.
Whether this event entry is enabled (valid) or disabled.
Text string identifying who configured this entry.
System up time when this report was last started.
Index number of the host table for which this top N report will be
prepared.
Type of counter (and corresponding integer value) activated with this
entry: as InPackets (1), OutPackets (2), InOctets (3), OutOctets (4),
OutErrors (5), Broadcast packets (6), or Multicast packets (7).
Collection time (in seconds) for this report.
Collection time left for this report if still in progress.
Maximum number of hosts requested for the top N table.
Actual maximum number of hosts in the top N table. Depending on
system resources, this may differ from the Requested Size value.
Amount of change in the counter type (InPackets, OutPackets, etc.)
during the sampling interval.
MAC address of the host.
show rmon topN