show port mac
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the default gateway:
Matrix(rw)->clear ip route default
show port mac
Use this command to display the MAC address(es) for one or more ports.
Syntax
show port mac [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, MAC addresses for all ports will be displayed.
Mode
Switch command, Read‐Only.
Usage
These are port MAC addresses programmed into the device during manufacturing. To show the
MAC addresses learned on a port through the switching process, use the show mac command as
described in "show mac" on page 12‐10.
Example
This example shows how to display the MAC address for 1‐Gigabit Ethernet port 4 in module 2:
Matrix(rw)->show port mac fe.2.4
Port
------------
fe.2.4
(Optional) Displays MAC addresses for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
MAC Address
----------------------
00-01-F4-DA-32-FE
Managing Switch Network Addresses and Routes
Enterasys Matrix DFE-Gold Series Configuration Guide 12-9