Clear Ip Ospf Process; Show Ip Ospf Virtual Links Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

clear ip ospf process

Adjacency State FULL
Table 21‐6 provides an explanation of the command output.
Table 21-6 show ip ospf virtual links Output Details
Output...
Virtual Link
Transit area
via interface
Cost of using
Transit Delay
State
Timer intervals configured
Adjacency State
clear ip ospf process
Use this command to reset the OSPF process.
Syntax
clear ip ospf process process-id
Parameters
process‐id
Defaults
None.
Mode
Router command, Privileged EXEC: Matrix>Router#
Usage
This command will require adjacencies to be reestablished and routes to be reconverged.
Example
This example shows how to reset OSPF process 1:
Matrix>Router#clear ip ospf process 1
Hello 10, Dead 40, Wait 40, Retransmit 5
What it displays...
ID of the virtual link neighbor, and the virtual link status, which is up or
down.
ID of the transit area through which the virtual link is configured.
Router's interface into the transit area.
OSPF cost of routing through the virtual link.
Time (in seconds) added to the LSA (Link State Advertisement) age
field when the LSA is transmitted through the virtual link.
Interface state assigned to a virtual link, which is point-to-point.
Timer intervals configured for the virtual link, including Hello, Dead,
Wait, and Retransmit intervals.
State of adjacency between this router and the virtual link neighbor of
this router.
Specifies the process ID, an internally used identification number for
each instance of the OSPF routing process run on a router. Valid values
are 1 to 65535.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-49
Configuring OSPF