Show Spantree Stats - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
For information about...
show spantree debug
clear spantree debug

show spantree stats

Use this command to display Spanning Tree information for one or more ports.
Syntax
show spantree stats [port port-string] [sid sid] [active]
Parameters
port port‐string
sid sid
active
Defaults
• If port‐string is not specified, Spanning Tree information for all ports will be displayed.
• If sid is not specified, information for Spanning Tree 0 will be displayed.
• If active is not specified information for all ports will be displayed regardless of whether or
not they have received BPDUs.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the device's Spanning Tree configuration:
Matrix(rw)->show spantree stats
Spanning tree status
Spanning tree instance
Designated Root MacAddr
Designated Root Priority
Designated Root Cost
Designated Root Port
Root Max Age
Root Hello Time
Root Forward Delay
Bridge ID MAC Address
Bridge ID Priority
6-6 Spanning Tree Configuration
(Optional) Displays information for the specified port(s). For a detailed
description of possible port‐‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays information for a specific Spanning Tree identifier.
If not specified, SID 0 is assumed.
(Optional) Displays information for ports that have received STP
BPDUs since boot.
- enabled
- 0
- 00-e0-63-9d-c1-c8
- 0
- 10000
- lag.0.1
- 20 sec
- 2 sec
- 15 sec
- 00-01-f4-da-5e-3d
- 32768
show spantree stats
Refer to page...
6-46
6-48