Show Radius; Purpose; Commands; Configuring Radius - Enterasys Matrix DFE-Gold Series Configuration Manual

show radius

Configuring RADIUS

Purpose

To perform the following:
• Review the RADIUS client/server configuration on the device.
• Enable or disable the RADIUS client.
• Set local and remote login options.
• Set primary and secondary server parameters, including IP address, timeout period,
authentication realm, and number of user login attempts allowed.
• Reset RADIUS server settings to default values.
• Configure a RADIUS accounting server.

Commands

For information about...
show radius
set radius
clear radius
show radius accounting
set radius accounting
clear radius accounting
show radius
Use this command to display the current RADIUS client/server configuration.
Syntax
show radius [state | retries authtype || timeout | server [index | all]]
Parameters
state
retries
authtype
server
timeout
index | all
(Optional) Displays the RADIUS client's enable status.
(Optional) Displays the number of retry attempts before the RADIUS
server times out.
(Optional) Displays the RADIUS server's authentication type.
(Optional) Displays RADIUS server configuration information.
(Optional) Displays the maximum amount of time (in seconds) to
establish contact with the RADIUS server before retry attempts begin.
(Optional) Displays configuration information for a specified server or
all RADIUS servers.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-53
Configuring RADIUS
Refer to page...
25-53
25-54
25-55
25-56
25-57
25-58