Show Gvrp Configuration Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

show garp timer
Parameters
port‐string
Defaults
If port‐string is not specified, GARP timer information will be displayed for all ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display GARP timer information on Fast Ethernet ports 1 through 10
in module 1:
Matrix(rw)->show garp timer fe.1.1-10
Port based GARP Configuration: (Timer units are centiseconds)
Port Number
-----------
fe.1.1
fe.1.2
fe.1.3
fe.1.4
fe.1.5
fe.1.6
fe.1.7
fe.1.8
fe.1.9
fe.1.10
Table 7‐5 provides an explanation of the command output. For details on using the set gvrp
command to enable or disable GVRP, refer to "set gvrp" on page 7‐26. For details on using the set
garp timer command to change default timer values, refer to "set garp timer" on page 7‐27.
Table 7-5 show gvrp configuration Output Details
Output...
Port Number
Join
Leave
Leaveall
(Optional) Displays GARP timer information for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Note: For a functional description of the terms join, leave, and leaveall timers, refer to the standard
IEEE 802.1Q documentation, which is not supplied with this device.
Join
---------- ----------
20
20
20
20
20
20
20
20
20
20
Leave Leaveall
----------
60 1000
60 1000
60 1000
60 1000
60 1000
60 1000
60 1000
60 1000
60 1000
60 1000
What it displays...
Port designation. For a detailed description of possible port-string
values, refer to "Port String Syntax Used in the
Join timer setting.
Leave timer setting.
Leavall timer setting.
Enterasys Matrix DFE-Gold Series Configuration Guide 7-25
Enabling/Disabling GVRP
CLI" on page 4-2.