fe.1.1-10
This example shows the port‐string syntax for specifying the 1‐Gigabit Ethernet port 14 in the
module in chassis slot 3.
ge.3.14
This example shows the port‐string syntax for specifying Fast Ethernet ports 1 and 3 and Gigabit
Ethernet port 11 in the module in chassis slot 1:
fe.1.1,fe.1.3;ge.1.11
This example shows the port‐string syntax for specifying Fast Ethernet ports 1, 3, 7, 8, 9 and 10 in
the module in chassis slot 1:
fe.1.1,fe.1.3,fe.1.7-10
This example shows the port‐string syntax for specifying the 10‐Gigabit Ethernet port 2 of the
module in chassis slot 3.
tg.3.1
This example shows the port‐string syntax for specifying all 1‐Gigabit Ethernet ports in the module
in chassis slot 3.
ge.3.*
This example shows the port‐string syntax for specifying all 10‐Gbps Ethernet ports in the chassis.
tg.*.*
This example shows the port‐string syntax for specifying all ports (of any interface type) in all
modules in the chassis
Setting Console Port Properties
Purpose
To review and set parameters for one or more of the device's console ports, including baud rate,
auto baud detection, stopbits and parity.
Commands
The commands used to review and configure console port settings are listed below and described
in the associated section as shown.
For information about...
show console
clear console
show console baud
set console baud
clear console baud
show console flowcontrol
set console flowcontrol
clear console flowcontrol
*.*.*
Setting Console Port Properties
Enterasys Matrix DFE-Gold Series Configuration Guide 4-3
Refer to page...
4-4
4-4
4-5
4-5
4-6
4-6
4-7
4-7