Using Webview; Starting And Navigating The Command Line Interface - Enterasys Matrix DFE-Gold Series Configuration Manual

Note: Depending on which Matrix Series device you are using, your default command prompt may
be different than the examples shown.

Using WebView

By default WebView (Enterasys Networks' embedded web server for device configuration and
management tasks) is enabled on TCP port number 80 of the Matrix Series device. You can verify
WebView status, enable or disable WebView, as described in the following section.
Displaying WebView status:
To display WebView status, enter show webview at the CLI command prompt.
This example shows that WebView is enabled on TCP port 80, the default port number.
Matrix(rw)->show webview
WebView is Enabled. Configured listen port is 80.
Enabling / disabling WebView:
To enable or disable WebView, enter set webview {enable o disable} at the CLI command prompt.
This example shows how to enable WebView.
Matrix(rw)->set webview enable

Starting and Navigating the Command Line Interface

Using a Console Port Connection
Note: By default, the Matrix Series device is configured with three user login accounts: ro for Read-
Only access; rw for Read-Write access; and admin for super-user access to all modifiable
parameters. The default password is set to a blank string. For information on changing these default
settings, refer to
Once you have connected a terminal to the local console port as described in your Matrix Series
Installation Guide, the startup screen, Figure
Interface (CLI) by
• Using a default user account, as described in "Logging in with a Default User Account" on
page 2‐7, or
• Using an administratively‐assigned user account as described in "Logging in with
Administratively Configured Account" on page 2‐8.
Logging in with a Default User Account
If this is the first time your are logging in to the Matrix Series device, or if the default user accounts
have not been administratively changed, proceed as follows:
1. At the login prompt, enter one of the following default user names:
– ro for Read‐Only access,
– rw for Read‐Write access.
– admin for Super User access.
2. Press ENTER. The Password prompt displays.
"Setting User Accounts and
2‐1, will display. You can now start the Command Line
Startup and General Configuration Summary
Passwords" on page 2-15.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-7