show port operstatuscause
Table 4-2 show port counters Output Details
Output...
MIB2 Interface Counters
802.1Q Switch Counters
show port operstatuscause
Use this command to display the causes configured to place operating status to a down or
dormant state for one or more ports.
Syntax
show port operstatuscause [port-string] [any] [modifiable][admin] [linkloss]
[linkflap] [self] [init] [flowlimit] [policy] [cos] [dot1x] [lag]
Parameters
port‐string
any
modifiable
admin
linkloss
linkflap
self
init
flowlimit
policy
cos
dot1x
lag
Defaults
If no options are specified, causes for all ports will be displayed.
What it displays...
MIB2 network traffic counts
Counts of frames received, transmitted, and filtered.
(Optional) Displays causes for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays a table of all causes.
(Optional) Displays a table of modifiable causes.
(Optional) Displays ports down due to adminStatus.
(Optional) Displays ports down due to link loss.
(Optional) Displays ports down due to link flap violation. For more
information on configuring the link flap function, refer to "Configuring
Link Traps and Link Flap Detection" on page 4‐39.
(Optional) Displays ports down due to a hardware cause.
(Optional) Displays ports in initialization phase.
(Optional) Displays ports down due to a flow limiting constraint. For
more information on configuring flow limiting, which is also known as
flow setup throttling, refer to "Configuring Flow Setup Throttling
(FST)" on page 24‐25.
(Optional) Displays ports down due to policy restriction. For more
information on configuring user policies, refer to Chapter
(Optional) Displays ports down due to Class of Service constraint. For
more information on configuring Class of Service, refer to "Configuring
Policy Class of Service (CoS)" on page 8‐21.
(Optional) Displays ports dormant due to 802.1X enforcement. For
more information on configuring 802.1X, refer to "Configuring 802.1X
Authentication" on page 25‐2.
(Optional) Displays ports dormant due to Link Aggregation Group
(LAG) membership. For more information on configuring LAG, refer to
"Configuring Link Traps and Link Flap Detection" on page 4‐39.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-17
Reviewing Port Status
8.