Ip Rip Disable-Triggered-Updates - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RIP
Usage
This command is necessary for enabling CIDR for RIP on the Enterasys Matrix Series device.
By default, RIP version 2 supports automatic route summarization, which summarizes
subprefixes to the classful network boundary when crossing network boundaries. Disabling
automatic route summarization enables CIDR, allowing RIP to advertise all subnets and host
routing information on the Enterasys Matrix Series device. To verify which routes are summarized
for an interface, use the show ip protocols command as described in "show ip protocols" on
page 16‐22.
The auto‐summary version of the command re‐enables automatic route summarization.
Example
This example shows how to disable RIP automatic route summarization:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#no auto-summary

ip rip disable-triggered-updates

Use this command to prevent RIP from sending triggered updates.
Syntax
ip rip disable-triggered-updates
no ip rip disable-triggered-updates
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
Triggered updates are sent when there is a change in the network and a new route with a lower
metric is learned, or an old route is lost. This command stops or starts the interface from sending
these triggered updates. By default triggered updates are enabled on a RIP interface.
The "no" form of this command allows RIP to respond to a request for a triggered update.
Example
This example shows how to prevent RIP from responding to a request for triggered updates on
VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip disable-triggered-updates
21-14 Routing Protocol Configuration
ip rip disable-triggered-updates