Configuring System Logging
Defaults
If index is not specified, all Syslog server information will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display Syslog server configuration information. For an explanation
of the command output, refer back to Table
Matrix(rw)->show logging server
IP Address
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5)
2 132.140.90.84
set logging server
Use this command to configure a Syslog server.
Syntax
set logging server index [ip-addr ip-addr] [facility facility] [severity severity]
[descr descr] [port port] [state {enable | disable}]
Parameters
index
ip‐addr ip‐addr
facility facility
severity severity
descr descr
port port
state enable | disable
10-4 System Logging Configuration
10‐1.
Facility Severity
local4 warning(5)
Specifies the server table index number for this server. Valid values are
1 ‐ 8.
(Optional) Specifies the Syslog message server's IP address.
(Optional) Specifies the server's facility name. Valid values are: local0 to
local7.
(Optional) Specifies the severity level at which the server will log
messages. Valid values and corresponding levels are:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
(Optional) Specifies a textual string description of this facility/server.
(Optional) Specifies the default UDP port the client uses to send to the
server.
(Optional) Enables or disables this facility/server configuration.
Description
Port Status
default
514 enabled
default
514 enabled
set logging server