Clear Port Inlinepower - Enterasys Matrix DFE-Gold Series Configuration Manual

clear port inlinepower

Parameters
port‐string
admin off | auto
priority critical | high
| low
type type
powerlimit
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable PoE on port fe.3.1 with critical priority:
Matrix(rw)->set port inlinepower fe.3.1 admin auto priority critical
clear port inlinepower
Use this command to reset PoE parameters on one or more ports to default values.
Syntax
clear port inlinepower port-string {[admin] [priority] [type] [powerlimit]}
Parameters
port‐string
admin
priority
type
powerlimit
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to rest the PoE priority on port fe.3.1 to low:
Matrix(rw)->clear port inlinepower fe.3.1 priority
Specifies the port(s) on which to configure PoE.
Sets the PoE administrative state to off (disabled) or auto (on).
Sets the port(s) priority for the PoE allocation algorithm to critical
(highest), high or low.
Specifies a string describing the type of device connected to a port.
powerlimit
Sets the maximum power allowed on this port in megawatts. Valid
values are 0 ‐ 15400.
Specifies the port(s) on which to reset PoE.
Resets the PoE administrative state to auto (on).
Resets the port(s) priority for the PoE allocation algorithm to low.
Resets the port type to an empty string.
Resets the maximum power to 15400 megawatts.
Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-71