Reviewing Existing VLANs
Parameters
static
vlan‐list
Defaults
If no options are specified, all information related to static and dynamic VLANs will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display information for VLAN 1. In this case, VLAN 1 is named
"DEFAULT VLAN" and it is enabled to operate. Ports allowed to transmit frames belonging to
VLAN 1 are listed as egress ports. Ports that won't include a VLAN tag in their transmitted frames
are listed as untagged ports. There are no forbidden ports (prevented from transmitted frames) on
VLAN 1:
Matrix(rw)->show vlan 1
VLAN: 1
VLAN Type: Permanent
Creation Time: 4 days 9 hours 4 minutes 50 seconds ago
Egress Ports
host.0.1, fe.1.1-10, ge.2.1-4, fe.3.1-7, lag.0.1-32
Forbidden Egress Ports
None.
Untagged Ports
host.0.1, fe.1.1-10, ge.2.1-4, fe.3.1-7, lag.0.1-32
Table
7‐2 provides an explanation of the command output.
Table 7-2 show vlan Output Details
Output...
VLAN
NAME
Status
VLAN Type
FID
Creation Time
Egress Ports
7-4 802.1Q VLAN Configuration
(Optional) Displays information related to static VLANs. Static VLANs
are manually created using the set vlan command ("set vlan" on
page 7‐6), SNMP MIBs, or the WebView management application. The
default VLAN, VLAN 1, is always statically configured and can't be
deleted. Only ports that use a specified VLAN as their default VLAN
(PVID) will be displayed.
(Optional) Displays information for a specific VLAN or range of
VLANs.
NAME: DEFAULT VLAN
FID: 1
What it displays...
VLAN ID.
Name assigned to the VLAN.
Whether it is enabled or disabled.
Whether it is permanent (static) or dynamic.
Filter Database ID of which this VLAN is a member.
Time elapsed since the VLAN was created.
Ports configured to transmit frames for this VLAN.
show vlan
Status: Enabled