Configuring RADIUS
Parameters
state
retries
timeout
server
realm
index | all
Defaults
•
If index or all is not specified for clearing RADIUS server, all RADIUS server settings will be
deleted.
•
If no other optional parameters are specified, all RADIUS settings will be cleared.
Mode
Switch command, Read‐Write.
Examples
This example shows how to clear all settings on all RADIUS servers:
Matrix(rw)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
Matrix(rw)->clear radius timeout
show radius accounting
Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [updateinterval] | [intervalminimum] | [state] | [server
{index | all}]
Parameters
updateinterval
intervalminimum
state
server index | all
25-56 Authentication Configuration
(Optional) Resets the RADIUS client state to the default setting of
disabled.
(Optional) Resets the maximum number of attempts a user can contact
the RADIUS server before timing out to 3.
(Optional) Resets the maximum amount of time to establish contact
with the RADIUS server before timing out to 20 seconds.
(Optional) Deletes server settings.
(Optional) Resets the realm setting to allowing any authentication.
Resets settings for a specified server or all RADIUS servers.
(Optional) Displays the number of seconds between each RADIUS
accounting interim update (when accumulated accounting data is sent
to the server for a session.)
(Optional) Displays the minimum update interval setting. This controls
the frequency of RADIUS accounting updates.
(Optional) Displays the RADIUS accounting enable state.
(Optional) Displays one or all RADIUS accounting server
configurations.
show radius accounting