Set Sntp Poll-Timeout; Clear Sntp Poll-Timeout - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Simple Network Time Protocol (SNTP)
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the number of SNTP poll retries:
Matrix(rw)->clear sntp poll-retry

set sntp poll-timeout

Use this command to set the poll timeout (in seconds) for a response to a unicast SNTP request.
Syntax
set sntp poll-timeout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the SNTP poll timeout to 10 seconds:
Matrix(rw)->set sntp poll-timeout 10

clear sntp poll-timeout

Use this command to clear the SNTP poll timeout.
Syntax
clear sntp poll-timeout
Parameters
None.
Defaults
None.
13-8 SNTP Configuration
Specifies the poll timeout in seconds. Valid values are 1 to 30.
set sntp poll-timeout