Show Ip Pim Rp Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip pim rp
Parameters
group
mapping
multicast‐group‐address (Optional) Displays RP information for a specific multicast group IP
Defaults
If no optional parameters are specified, all active RPs will be displayed.
Mode
Router command, Privileged EXEC: Matrix>Router#
Examples
This example shows how to display information about active RPs:
Matrix>Router#show ip pim rp
Group: 225.1.2.3, RP: 192.168.41.1, uptime 07:49:53, expires 00:02:09
This example shows how to display RP mapping information:
Matrix>Router#show ip pim rp mapping
PIM Group to RP Mapping:
Group(s): 228.3.3.3/32
Group(s): 224.0.0.0/4
Table 17‐4 provides an explanation of the command output.
Table 17-4 show ip pim rp Output Details
Output...
Group(s)
RP
Priority
Expiry
Uptime
(Optional) Displays active RPs for any existing multicast group(s).
(Optional) Displays all RP mappings.
address.
RP: 41.41.1.1, via Static Configuration
RP: 192.168.41.1, Priority:
RP: 192.168.91.1, Priority:
2, Expiry: 00:01:30, Uptime: 07:49:31
5, Expiry: 00:01:30, Uptime: 07:49:31
What it displays...
Address of the multicast group(s) about which to display RP data.
Address of the RP for that group.
RP priority value.
Period (in hours:minutes:seconds) in which the next bootstrap
message is due from this BSR.
Interval that this router has been up in hours:minutes:seconds.
Enterasys Matrix DFE-Gold Series Configuration Guide 17-9
Configuring PIM