Show Ip Pim Rp; Show Ip Pim Neighbor Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring PIM
Parameters
interface
Defaults
If not specified, information about all PIM interfaces will be displayed.
Mode
Router command, Privileged EXEC: Matrix>Router#
Example
This example shows how to display PIM neighbor information:
Matrix>Router#show ip pim neighbor
Neighbor Address
------------------------------------------------------------------------
10.0.0.2
Table 17‐3 provides an explanation of the command output.
Table 17-3 show ip pim neighbor Output Details
Output...
Neighbor Address
Vlan
DR Priority
Uptime
Expires
Mode
(DR)

show ip pim rp

Use this command to display the active rendezvous points (RPs) that are cached with associated
multicast routing entries.
Syntax
show ip pim rp [group | mapping | multicast-group-address]
17-8 PIM Configuration
(Optional) Displays information about a specific PIM interface. This
interface must be enabled with PIM as described in "ip pim sparse
mode" on page 17‐2.
Vlan DR Priority
10 1
What it displays...
IP address of the PIM neighbor.
VLAN ID of the PIM interface.
DR priority of the neighbor.
Interval in hours, minutes, and seconds the entry has been in the PIM
neighbor table.
Interval in hours, minutes, and seconds until the entry will be removed
from the IP multicast routing table.
Mode in which the interface is operating.
Indicates that this neighbor is a designated router on the LAN.
Uptime Expires
00:03:34 00:01:40
show ip pim rp
Mode ------
PIMSM_MODE (DR)