Show Spantree Mstmap; Set Spantree Mstmap - Enterasys Matrix DFE-Gold Series Configuration Manual

show spantree mstmap

show spantree mstmap
Use this command to display the mapping of a filtering database ID (FID) to a Spanning Trees.
Since VLANs are mapped to FIDs, this shows to which SID a VLAN is mapped.
Syntax
show spantree mstmap [fid fid]
Parameters
fid fid
Defaults
If fid is not specified, information for all assigned FIDs will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SID to FID mapping information for FID 1. In this case, no
new mappings have been configured:
Matrix(rw)->show spantree mstmap fid 1
FID:
1

set spantree mstmap

Use this command to map one or more filtering database IDs (FIDs) to a SID. Since VLANs are
mapped to FIDs, this essentially maps one or more VLAN IDs to a Spanning Tree (SID).
Syntax
set spantree mstmap fid [sid sid]
Parameters
fid
sid sid
Defaults
If sid is not specified, FID(s) will be mapped to Spanning Tree 0.
Mode
Switch command, Read‐Write.
(Optional) Displays information for specific FIDs.
SID:
0
Specifies one or more FIDs to assign to the MST. Valid values are 1 ‐
4093, and must correspond to a VLAN ID created using the set vlan
command as described in "set vlan" on page
(Optional) Specifies a Multiple Spanning Tree ID. Valid values are 1 ‐
4094, and must correspond to a SID created using the set msti
command as described in "set spantree msti" on page 6‐14.
Configuring Spanning Tree Bridge Parameters
7‐6.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-15