Ip Ospf Transmit-Delay - Enterasys Matrix DFE-Gold Series Configuration Manual

ip ospf transmit-delay

Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command resets the retransmit interval value to the default.
Example
This example shows how to set the OSPF retransmit interval for VLAN 1 to 20:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf retransmit-interval 20
ip ospf transmit-delay
Use this command to set the amount of time required to transmit a link state update packet on an
interface.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
Parameters
seconds
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command resets the retransmit interval value to the default.
Example
This example shows how to set the time required to transmit a link state update packet on VLAN
1 at 20 seconds:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf transmit-delay 20
Specifies the transmit delay in seconds. Valid values are from 1 to 65535.
Default: 1 Second.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-27
Configuring OSPF