Configuring RMON
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to delete RMON statistics entry 2:
Matrix(rw)->clear rmon stats 2
show rmon history
Use this command to display RMON history properties and statistics. The RMON history group
records periodic statistical samples from a network.
Syntax
show rmon history [port-string] [wide] [interval]
Parameters
port‐string
wide
interval
Defaults
If port‐string is not specified, information about all RMON history entries will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display RMON history entries for Fast Ethernet port 14 in module 3.
A control entry displays first, followed by actual entries corresponding to the control entry. In this
case, the default settings for entry owner, sampling interval, and maximum number of entries.
(buckets) have not been changed from their default values (as described in "set rmon history" on
page
11‐19). For a description of the types of statistics shown, refer to Table
Matrix(rw)->show rmon history fe.3.14
Port: fe.3.14
---------------------------------------
Index 1001
Status
Owner
Data Source
Interval
Buckets Requested = 50
Buckets Granted
11-18 Network Monitoring Configuration
(Optional) Displays RMON history entries for specific port(s).
(Optional) Display most important stats, one line per entry.
(Optional) Summarize history over a fixed interval.
= 1 valid
= monitor
= 1.3.6.1.2.1.2.2.1.1.11001
= 30
= 50
show rmon history
11‐3: