Show Port Inlinepower; Set Port Inlinepower - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Power over Ethernet (PoE)
Mode
Switch command, Read‐Write.
Example
This example shows how to reset PoE trap messaging for module 1 to disabled:
Matrix(rw)->clear inlinepower psetrap 1

show port inlinepower

Use this command to display all ports supporting PoE.
Syntax
show port inlinepower [port-string]
Parameters
port‐string
Defaults
If not specified, information for all PoE ports will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display PoE information for Fast Ethernet ports 11, 12 and 13 in
module 1:
Matrix(rw)->show port inlinepower fe.1.1-2
Port
------- ------------- ---------------- ------ -------- ----- ----- ----- ------
fe.1.11 Wireless 1
fe.1.12 Wireless 2
fe.1.13 Wireless 3

set port inlinepower

Use this command to configure PoE parameters on one or more ports.
Syntax
set port inlinepower port-string {[admin {off | auto}] [priority {critical | high
| low}] [type type] [powerlimit powerlimit]}
2-70 Startup and General Configuration
(Optional) Displays information for specific PoE port(s).
Oper
Type Status
(truncated)
delivering power auto
delivering power auto
searching
Admin
Status Priority Class Limit Usage Type
critical 0
high 1
auto low 3
show port inlinepower
Power Power PD
(mW) (mW)
16800 7500 legacy
16800 7500 802.3af
16800 7500 other