Configuring NetFlow
Parameters
ip‐address
udp‐port
Defaults
Since only one collector address per Enterasys Matrix system is supported, entering the IP address
and UDP port information is not required. Executing this command without any parameters will
return the collector address to "Not Configured."
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the NetFlow collector address:
Matrix(rw)->clear netflow export-destination
set netflow export-interval
Use this command to configure the NetFlow export interval.
Syntax
set netflow export-interval interval
Parameters
interval
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Each DFE blade in the Enterasys Matrix system will transmit a NetFlow packet when:
•
It has accumulated the maximum number of NetFlow records per packet, which is 30, or
•
It has accumulated fewer than 30 NetFlow records and the active flow timer has expired, or
•
The flow expires (ages out or is invalidated).
Example
This example shows how to set the NetFlow export interval to 10 minutes:
Matrix(rw)->set netflow export-interval 10
15-6 NetFlow Configuration
(Optional) Specifies the IP address of the NetFlow collector to clear.
(Optional) Specifies the UDP port number used by NetFlow collector.
Set the active flow timer value, between 1 to 60 minutes. The default
value is 30 minutes.
set netflow export-interval