Key; Key-String - Enterasys Matrix DFE-Gold Series Configuration Manual

key

Example
This example shows how to create a RIP authentication key chain called "md5key":
Matrix>Router(config)#key chain md5key
key
Use this command to identify a RIP authentication key on a key chain.
Syntax
key key-id
no key key-id
Parameters
key‐id
Defaults
None.
Mode
Router command, Key chain configuration: Matrix>Router(config‐keychain)#
Usage
This release of the Enterasys Matrix Series firmware supports only one key per key chain.
The "no" form of this command removes the key from the key chain.
Example
This example shows how to create authentication key 3 within the key chain called "md5key":
Matrix>Router(config-router)#key chain md5key
Matrix>Router(config-keychain)#key 3

key-string

Use this command to specify a RIP authentication string for a key. Once configured, this string
must be sent and received in RIP packets in order for them to be authenticated.
Syntax
key-string text
no key-string text
Specifies an authentication number for a key. Valid number are from 0
to 4294967295. Only one key is supported per key chain in this
Enterasys Matrix Series release.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-9
Configuring RIP