Configuring Port Web Authentication (PWA)
Defaults
If port‐string is not specified, quiet period will be set for all ports.
Mode
Read‐Write.
Example
This example shows how to set the PWA quiet period to 30 seconds for ports fe.1.5‐7:
Matrix(rw)->set pwa quietperiod 30 fe.1.5-7
set pwa maxrequests
Use this command to set the maximum number of log on attempts allowed before transitioning
the PWA port to a held state.
Syntax
set pwa maxrequests maxrequests [port-string]
Parameters
maxrequests
port‐string
Defaults
If port‐string is not specified, maximum requests will be set for all ports.
Mode
Read‐Write.
Example
This example shows how to set the PWA maximum requests to 3 for all ports:
Matrix(rw)->set pwa maxrequests 3
set pwa portcontrol
Use this command to set the PWA port control mode.
Syntax
set pwa portcontrol {enable | disable} [port-string]
25-24 Authentication Configuration
Specifies the maximum number of log on attempts.
(Optional) Sets the maximum requests for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
set pwa maxrequests