Set Rmon Capture - Enterasys Matrix DFE-Gold Series Configuration Manual

set rmon capture

set rmon capture
Use this command to configure an RMON capture entry, or to enable or disable an existing entry.
Syntax
set rmon capture index {channel [action {lock | wrap}] [slice slice] [loadsize
loadsize] [offset offset] [asksize asksize] [owner owner]} | {enable | disable}
Parameters
index
channel
action lock | wrap
slice slice
loadsize loadsize
offset offset
asksize asksize
owner
enable | disable
Defaults
• If not specified, action defaults to lock.
• If not specified, offset defaults to 0.
• If not specified, asksize defaults to 1 (which will request as many octets as possible)
• If slice and loadsize are not specified, 100 will be applied.
• If owner is not specified, it will be set to monitor.
Mode
Switch command, Read‐Write.
Example
This example shows how to create RMON capture entry 1 to "listen" on channel 628:
Matrix(rw)->set rmon capture 1 628
Specifies a buffer control entry.
Specifies the channel to which this capture entry will be applied.
(Optional) Specifies the action of the buffer when it is full as:
• lock ‐ Packets will cease to be accepted
• wrap ‐ Oldest packets will be overwritten
(Optional) Specifies the maximum octets from each packet to be saved
in a buffer. (default: 100)
(Optional) Specifies the maximum octets from each packet to be
downloaded from the buffer (default: 100)
(Optional) Specifies that the first octet from each packet that will be
retrieved.
(Optional) Specifies that the requested maximum octets will be saved in
this buffer.
(Optional) Specifies the name of the entity that configured this entry.
Enables or disables an existing RMON capture entry.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-41
Configuring RMON