Show Lacp - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring LACP
For information about...
clear singleportlag
show port lacp
set port lacp
clear port lacp
show lacp flowRegeneration
set lacp flowRegeneration
clear lacp flowRegeneration
show lacp outportAlgorithm
set lacp outportAlgorithm
clear lacp outportAlgorithm

show lacp

Use this command to display the global LACP enable state, or to display information about one or
more aggregator ports.
Syntax
show lacp [state | port-string]
Parameters
state
port‐string
Defaults
• If state is not specified, aggregator information will be displayed for specified ports.
• If port‐string is not specified, link aggregation information for all ports will be displayed.
Mode
Switch command, Read‐Only.
Usage
Each Matrix Series module provides 4 virtual link aggregator ports, which are designated in the
CLI as lag.0.1 through lag.0.4. Once underlying physical ports (i.e.; fe.x.x, ge.x.x) are associated
with an aggregator port, the resulting aggregation will be represented as one Link Aggregation
Group (LAG) with a lag.x.x port designation.
Example
This example shows how to display information for aggregator port 4:
Matrix(rw)->show lacp lag.0.484
Aggregator:
4-58 Port Configuration
(Optional) Displays the global LACP enable state.
(Optional) Displays LACP information for specific LAG port(s). Valid
port designations are lag.0.1 ‐ 4.
lag.0.484
show lacp
Refer to page...
4-64
4-65
4-66
4-68
4-69
4-69
4-70
4-70
4-71
4-71