Set Rad; Show Rad - Enterasys Matrix DFE-Gold Series Configuration Manual

Managing Switch Network Addresses and Routes
Parameters
ip | all
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to delete entry 10.1.10.10 from the ARP table:
Matrix(rw)->clear arp 10.1.10.10

show rad

Use this command to display the status of the RAD (Runtime Address Discovery) protocol on the
switch.
Syntax
show rad
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display RAD status:
Matrix(rw)->show rad
RAD is currently enabled.

set rad

Use this command to enable or disable RAD (Runtime Address Discovery) protocol.
Syntax
set rad {enable | disable}
Parameters
enable | disable
12-4 Network Address and Route Management Configuration
Specifies the IP address in the ARP table to be cleared, or clears all ARP
entries.
Enables or disables RAD.
show rad