Set Cdp Auth - Enterasys Matrix DFE-Gold Series Configuration Manual

set cdp auth

Parameters
auto | disable |
enable
port‐string
Defaults
If port‐string is not specified, the CDP state will be globally set.
Mode
Switch command, Read‐Write.
Examples
This example shows how to globally enable CDP:
Matrix(rw)->set cdp state enable
This example shows how to enable the CDP for port fe.1.2:
Matrix(rw)->set cdp state enable fe.1.2
This example shows how to disable the CDP for port fe.1.2:
Matrix(rw)->set cdp state disable fe.1.2
set cdp auth
Use this command to set a global CDP authentication code.
Syntax
set cdp auth auth‐code
Parameters
auth‐code
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
This value determines a device's CDP domain. If two or more devices have the same CDP
authentication code, they will be entered into each otherʹs CDP neighbor tables. If they have
different authentication codes, they are in different domains and will not be entered into each
other's CDP neighbor tables.
Auto‐enables, disables or enables the CDP protocol on the specified
port(s). In auto‐enable mode, which is the default mode for all ports, a
port automatically becomes CDP‐enabled upon receiving its first CDP
message.
(Optional) Enables or disables CDP on specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Specifies an authentication code for the CDP protocol. This can be up to
16 hexadecimal values separated by commas.
Enterasys Matrix DFE-Gold Series Configuration Guide 3-5
Enterasys Discovery Protocol