Set Ciscodp Status; Show Port Ciscodp Info Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Cisco Discovery Protocol
fe.1.1
fe.1.2
fe.1.3
fe.1.4
fe.1.5
Table 3‐3 provides an explanation of the command output.
Table 3-3 show port ciscodp info Output Details
Output...
Port
State
VVID
Trust
CoS

set ciscodp status

Use this command to enable or disable Cisco Discovery Protocol globally on the device.
Syntax
set ciscodp status {auto | enable | disable}
Parameters
auto
enable
disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable Cisco Discovery Protocol on the device:
Matrix>set ciscodp status enable
3-10 Discovery Protocols Configuration
enabled none untrusted
enabled none untrusted
enabled none untrusted
enabled none untrusted
enabled none untrusted
What it displays...
Port designation.
Whether CiscoDP is enabled or disabled on this port. Default state of
enabled can be changed using the set ciscodp port command
ciscodp
Whether a Voice VLAN ID has been set on this port. Default of none
can changed using the set ciscodp port command
on page 3-12).
The trust mode of the port. Default of trusted can be changed using the
set ciscodp port command
The Class of Service priority value for untrusted traffic. The default of 0
can be changed using the set ciscodp port command
port" on page 3-12).
Globally enables only if CiscoDP PDUs are received.
Globally enables Cisco Discovery Protocol.
Globally disables Cisco Discovery Protocol.
0
0
0
0
1
port" on page 3-12).
("set ciscodp
set ciscodp status
("set
("set ciscodp port"
port" on page 3-12).
("set ciscodp