Set Rmon Stats; Clear Rmon Stats - Enterasys Matrix DFE-Gold Series Configuration Manual

set rmon stats

Table 11-3 show rmon stats Output Details (continued)
Output...
512 – 1023 Octets
1024 – 1518 Octets
set rmon stats
Use this command to configure an RMON statistics entry.
Syntax
set rmon stats index port-string [owner]
Parameters
index
port‐string
owner
Defaults
If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure RMON statistics entry 2 for fe.1.20:
Matrix(rw)->set rmon stats 2 fe.1.20

clear rmon stats

Use this command to delete one or more RMON statistics entries.
Syntax
clear rmon stats {index-list | to-defaults}
Parameters
index‐list
to‐defaults
What it displays...
Total number of frames, including bad frames, received that were
between 512 and 1023 bytes in length (excluding framing bits, but
including FCS bytes).
Total number of frames, including bad frames, received that were
between 1024 and 1518 bytes in length (excluding framing bits, but
including FCS bytes).
Specifies an index for this statistics entry.
Specifies port(s) to which this entry will be assigned. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Assigns an owner for this entry.
Specifies one or more stats entries to be deleted, causing them to
disappear from any future RMON queries.
Resets all history entries to default values. This will cause entries to
reappear in RMON queries.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-17
Configuring RMON