Clear Rmon Channel; Show Rmon Filter - Enterasys Matrix DFE-Gold Series Configuration Manual

clear rmon channel

Defaults
• If an action is not specified, packets will be accepted on filter matches.
• If not specified, control will be set to off.
• If onevent and offevent are not specified, none will be applied.
• If event status is not specified, ready will be applied.
• If a description is not specified, none will be applied.
• If owner is not specified, it will be set to monitor.
Mode
Switch command, Read‐Write.
Example
This example shows how to accept failed control on description "capture all"create an RMON
channel entry:
Matrix(rw)->set rmon channel 54313 fe.2.12
clear rmon channel
Use this command to clear an RMON channel entry.
Syntax
clear rmon channel index
Parameters
index
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear RMON channel entry 2:
Matrix(rw)->clear rmon channel 2

show rmon filter

Use this command to display one or more RMON filter entries.
Syntax
show rmon filter [index index | channel channel]
Specifies the channel entry to be cleared.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-37
Configuring RMON