Set Cep Initialize - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Convergence End Points (CEP) Phone Detection
Mode
Switch command, Read‐Write.
Usage
This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses
CiscoDP as its discovery method.
Once UDP and/or TCP phone detection has been specified using the set cep detection‐id protocol
command as described in "set cep detection‐id protocol" on page 25‐46, the protocols will use this
port range for detection matching.
Example
This example shows how to set port 65 as the minimum port to be used for convergence end
points detection for CEP group 1:
Matrix>set cep detection-id 1 portlow 65

set cep initialize

Use this command to clear all existing CEP connections for one or more CEP‐enabled ports.
Syntax
set cep initialize [port-string]
Parameters
port‐string
Defaults
If no port‐string is specified, all existing CEP connections on all ports are cleared.
Mode
Switch command, Read‐Write.
Usage
This command is similar to the clear cep users command.
Example
This example shows how to re‐initialize CEP ports fe.1.3‐5:
Matrix>set cep initialize fe.1.3-5
25-48 Authentication Configuration
(Optional) Specifies the CEP‐enabled port(s) to clear existing CEP
connections. This must be a port‐string enabled for CEP using the set
cep port command as described in "set cep port" on page 25‐43. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
set cep initialize