Starting and Configuring Telnet
Example
This example shows how to start a Telnet session to a host at 10.21.42.13:
Matrix(rw)->telnet 10.21.42.13
show router telnet
Use this command to display the state of Telnet service to the router.
Syntax
show router telnet
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the state of Telnet service to the router:
Matrix(rw)->show router telnet
Telnet to Router IP is enabled
set router telnet
Use this command to enable or disable Telnet service to the router interface IP address.
Syntax
set router telnet {enable | disable}
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable Telnet service to the router:
Matrix(rw)->set router telnet disable
2-78 Startup and General Configuration
show router telnet