Setting Console Port Properties
Defaults
If port‐string is not specified, stop bits per character will be displayed for all console ports.
Mode
Switch command, Read‐Write.
Example
This example shows how to show stop bits per character on com.1.1:
Matrix(rw)->show console stopbits com.1.1
Port
------------
com.1.1
set console stopbits
Use this command to set the stop bits per character for one or more console ports.
Syntax
set console stopbits {one | oneandhalf | two} [port-string]
Parameters
one | oneandhalf |
two
port‐string
Defaults
If port‐string is not specified, stop bits per character will be set for all console ports.
Mode
Switch command, Read‐Write.
Example
This example shows how to set stop bits per character to 2 for console port com.1.1:
Matrix(rw)->set console stopbits 2 com.1.1
clear console stopbits
Use this command to clear the stop bits per character for one or more console ports.
Syntax
clear console stopbits [port-string]
Parameters
port‐string
4-10 Port Configuration
StopBits
--------
one
Sets stop bits per character to 1, 1.5 or 2.
(Optional) Sets stop bits for specific console port(s).
(Optional) Clears stop bits for specific console port(s).
set console stopbits