Show Port Priority-Queue; Commands; Configuring Priority To Transmit Queue Mapping - Enterasys Matrix DFE-Gold Series Configuration Manual

show port priority-queue

Configuring Priority to Transmit Queue Mapping

Purpose
To perform the following:
• View the current priority to transmit queue mapping of each port, which includes both
physical and virtual ports.
• Configure each port to either transmit frames according to the port priority transmit queues
(set using the set port priority command described back in "set port priority" on page 22‐3),
or according to a priority based on a percentage of port transmission capacity (set using the
set priority queue command described in "set port priority‐queue" on page 22‐6).
• Clear current port priority queue settings for one or more ports.

Commands

For information about...
show port priority-queue
set port priority-queue
clear port priority-queue
show port priority-queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit queue (0 ‐ 15 depending on port type, with 0 being the lowest
priority) for each priority of the selected port.
Syntax
show port priority-queue [priority]
Parameters
priority
Defaults
If priority is not specified, all priority queue information will be displayed.
Mode
Switch command, Read‐Only.
Usage
A frame with a certain port priority is transmitted according to the settings entered using the set
priority queue command described in "set port priority‐queue" on page 22‐6.
(Optional) Displays queue levels for a specific priority value.
Enterasys Matrix DFE-Gold Series Configuration Guide 22-5
Configuring Priority to Transmit Queue Mapping
Refer to page...
22-5
22-6
22-7