show snmp targetaddr
Configuring SNMP Target Addresses
Purpose
To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command ("set snmp
targetparams" on page 5‐27).
Commands
For information about...
show snmp targetaddr
set snmp targetaddr
clear snmp targetaddr
show snmp targetaddr
Use this command to display SNMP target address information.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
targetAddr
volatile | nonvolatile
| read‐only
Defaults
•
If targetAddr is not specified, entries for all target address names will be displayed.
•
If not specified, entries of all storage types will be displayed for a target address.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SNMP target address information:
Matrix(rw)->show snmp targetaddr
Target Address Name
Tag List
IP Address
UDP Port#
Target Mask
Timeout
(Optional) Displays information for a specific target address name.
(Optional) When target address is specified, displays target address
information for a specific storage type.
= labmachine
= v2cTrap
= 10.2.3.116
= 162
= 255.255.255.255
= 1500
Enterasys Matrix DFE-Gold Series Configuration Guide 5-29
Configuring SNMP Target Addresses
Refer to page...
5-29
5-30
5-31