Clear Snmp Access - Enterasys Matrix DFE-Gold Series Configuration Manual

clear snmp access

• If write view is not specified, none will be applied.
• If notify view is not specified, none will be applied.
• If storage type is not specified, entries will be stored as permanent and will be held through
device reboot.
Mode
Switch command, Read‐Write.
Examples
This example permits the "powergroup" to manage all MIBs via SNMPv3:
Matrix(rw)->set snmp access powergroup security-model usm
This example grants the "powergroup" SNMPv3 management access from all router modules
when operating in router mode:
Matrix(rw)->set snmp access powergroup security-model usm context router prefix
clear snmp access
Use this command to clear the SNMP access entry of a specific group, including its set SNMP
security‐model, and level of security.
Syntax
clear snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context]
Parameters
groupname
security‐model v1 |
v2c | usm
noauthentication |
authentication |
privacy
context context
Defaults
• If security level is not specified, all levels will be cleared.
• If context is not specified, none will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear SNMP version 3 access for the "mis‐group" via the
authentication protocol:
Matrix(rw)->clear snmp access mis-group security-model usm authentication
Specifies the name of the SNMP group for which to clear access.
Specifies the security model to be cleared for the SNMP access group.
(Optional) Clears a specific security level for the SNMP access group.
(Optional) Clears a specific context for the SNMP access group. Enter / ‐
/ to clear the default context.
Enterasys Matrix DFE-Gold Series Configuration Guide 5-21
Configuring SNMP Access Rights